This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
usp:default_map [2012/12/14 15:42] admin [REG_UTILITY Register] |
usp:default_map [2012/12/17 21:14] admin [Default memory map] |
||
---|---|---|---|
Line 28: | Line 28: | ||
| 0x0113 | | REG_RS3_SPEED | GSR | Yes | Communication speed of the third RS232 interface. Value in Bd. Default 38400| | | 0x0113 | | REG_RS3_SPEED | GSR | Yes | Communication speed of the third RS232 interface. Value in Bd. Default 38400| | ||
| 0x0114 | | REG_RS4_SPEED | GSR | Yes | Communication speed of the fourth RS232 interface. Value in Bd. Default 38400| | | 0x0114 | | REG_RS4_SPEED | GSR | Yes | Communication speed of the fourth RS232 interface. Value in Bd. Default 38400| | ||
- | | 0x0115 | | REG_ETH_UTILITY | GSR | Yes | Ethernet utility register, see description | | + | | 0x0115 | | REG_ETH_UTILITY | GSR | Yes | Ethernet utility register, [[usp:default_map&#reg_eth_utility_register|see description]] | |
| 0x0116 | IP3,IP2 | IP1,IP0 | GSB | Yes | Module embedded Ethernet IP address | | | 0x0116 | IP3,IP2 | IP1,IP0 | GSB | Yes | Module embedded Ethernet IP address | | ||
| 0x0117 | M3,M2 | M1,M0 | GSB | Yes | Module embedded Ethernet Mask | | | 0x0117 | M3,M2 | M1,M0 | GSB | Yes | Module embedded Ethernet Mask | | ||
Line 70: | Line 70: | ||
^ 0xA3C1 | Perform software Reset | | ^ 0xA3C1 | Perform software Reset | | ||
==== REG_UTILITY Register ==== | ==== REG_UTILITY Register ==== | ||
+ | |||
+ | ^ Bit ^ Description ^ | ||
+ | | 0 | LED On/Off bit 1 = LED on 0 = LED off | | ||
+ | |||
+ | |||
+ | ==== REG_ETH_UTILITY Register ==== | ||
^ Bit ^ Description ^ | ^ Bit ^ Description ^ | ||
| 0 | DHCPEN, 1= DHCP is enabled, 0=DHCP disabled | | | 0 | DHCPEN, 1= DHCP is enabled, 0=DHCP disabled | | ||
- | | 1 | LED On/Off bit 1 = LED on 0 = LED off | | ||
==== REG_COMMAND Register ==== | ==== REG_COMMAND Register ==== | ||
Application speciffic, writing to this register will execute a command. | Application speciffic, writing to this register will execute a command. |