Differences

This shows you the differences between two versions of the page.

--- usp:default_map [2012/12/14 15:42] – [REG_UTILITY Register] admin
+++ usp:default_map [2015/04/16 16:27] (current) – external edit 127.0.0.1
@@ Line 28: / Line 28: @@
 |  0x0113  |   |  REG_RS3_SPEED  |  GSR  |  Yes  | Communication speed of the third RS232 interface. Value in Bd. Default 38400|
 |  0x0114  |   |  REG_RS4_SPEED  |  GSR  |  Yes  | Communication speed of the fourth RS232 interface. Value in Bd. Default 38400|
-|  0x0115  |   |  REG_ETH_UTILITY  |  GSR  |	 Yes  | Ethernet utility register, see description		|
+|  0x0115  |   |  REG_ETH_UTILITY  |  GSR  |	 Yes  | Ethernet utility register, [[usp:default_map&#reg_eth_utility_register|see description]]		|
 |  0x0116  |  IP3,IP2  |  IP1,IP0  |  GSB  |  Yes  | Module embedded Ethernet IP address |
 |  0x0117  |  M3,M2  |  M1,M0  |  GSB  |  Yes  | Module embedded Ethernet Mask |
@@ Line 70: / Line 70: @@
 ^ 0xA3C1  | Perform software Reset  |
 ==== REG_UTILITY Register ====
+^  Bit  ^  Description  ^
+|  0  | LED On/Off bit  1 = LED on   0 = LED off |
+==== REG_ETH_UTILITY Register ====
 ^  Bit  ^  Description  ^
 |  0  | DHCPEN, 1= DHCP is enabled, 0=DHCP disabled |
-|  1  | LED On/Off bit  1 = LED on   0 = LED off |
 ==== REG_COMMAND Register ====
 Application speciffic, writing to this register will execute a command.